Quick-action chuck will accept 1/64" - 1/8" (0.3 - 3.2mm) shanks. Primarily advantageous when working with HSS drill bits of different sizes.
20mm-system adaptation. For flange mounting of MICROMOT accessories.
Stable housing made of glass-fibre reinforced POLYAMIDE. With a pleasantly soft handle.
Slim, easily handled and light.
Quick-action chuck and electronic revolutions adjustment, with feedback effect (high engine power in the lower revolutions area). Specialty balanced, low noise DC motor with high life expectancy. A transformer is required for operation. We recommend MICROMOT network devices from 1.0A.
Direct voltage 12 - 18V. Power absorption up to 40W input. 5,000 - 20,000/min. Length: 8 21/32" (220mm). Weight: 0.51 lb (230g).
NO 28 512
This product can expose you to chemicals including lead, which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
The MICROMOT 50/EF can also be used with MICROMOT steel clamping devices. This is recommended when milling continuously at high lateral pressure. This makes it impossible for the shafts to become loosened after prolonged working. Using clamping devices makes true running better than using the quick-action chuck.
- Quick-action chuck will accept 1/64" - 1/8" (0.3 - 3.2mm) shanks. Primarily advantageous when working with HSS drill bits of different sizes.
- 20mm-system adaptation. For flange mounting of MICROMOT accessories.
- Stable housing made of glass-fibre reinforced POLYAMIDE. With a pleasantly soft handle.
The speed control of our 12 volt devices only works when operated via non-stabilised power supply units (e.g. all MICROMOT mains adapters). Connection to stabilised power supply units is possible. However, the devices will then operate with maximum rotational speeds (also applies to operation with batteries).
Weitere interessante Geräte und passendes Zubehör:
Bohr- und Fräsgeräte MICROMOT 50 und 50/E
Netzgeräte NG 2/E und NG 2/S
Netzgerät NG 5/E
Schutzvorrichtung für handgeführte MICROMOT-Geräte